Zuil Lamp
A simple idea, made by hand: a solid, cast-mineral base paired with natural wood dowels. The diffuser is entirely 3D-printed, and that's where the personality comes in, with a playful hit of color against the quiet mineral and wood. Every base is poured and finished one at a time, so no two are quite the same, made slowly in small batches rather than off a factory line. It's the kind of lamp that looks just as good on a bedside table as it does anchoring a reading corner, warming up a room without trying too hard.
Held together by balance
The structure is assembled by hand, with no glue and no screws. The dowels push outward, the diffuser holds them in, and the two forces lock each other in place. Nothing is permanent, so every part can be repaired or replaced.
Choose your style
Hover or tap the lamp to switch it on. Pick a colour, then a view below.
Cast, not molded
Every base is poured by hand from a mineral mix, then finished one at a time, small variations included.
Three, holding the light
Three pine dowels and not a single screw. They press outward against the diffuser, and that tension is what holds the lamp together.
3D-printed
A playful hit of color against the quiet mineral and wood.
Contact
Want to stock Zuil in your shop, or ask about a colour? Send a message and you'll get a reply from the person who makes them.
hello@zuildesign.nlMaking of
Casting, sanding, printing, assembling. The slow parts that don't show up in the studio photos.
